![]() So, if you want darkness outside at night – you can turn them off with a flip of the switch. No more forgetting to turn the lights off!Īnd, dusk to dawn lights also have a manual override. They turn on automatically at dusk and turn off automatically at dawn. Like the name implies, dusk to dawn flood lights have a photocell that senses the sunlight. I also found that the motion sensor lights were a bit more expensive than the next option. So, if you are expecting company one evening – you can’t just turn on the lights to help your visitors find your house easily.Īnd if you hear a noise outside at night, you can’t manually turn the lights on and peek out the window to investigate. This means that you cannot turn the lights on and off when there is no motion. The Problem With Motion Sensor Outside Lightsįirst, many automatic flood lights with motion sensors DO NOT have a manual override. They turn on automatically when they sense movement, and they turn off when the motion stops.īut I quickly found out that there were limitations that I did not like. Originally, I thought that motion sensor lights would be great. Option 1: Motion Sensing Flood Lightsīut when I started looking into flood lights with a motion sensor – I quickly realized that this was not the right solution for me. My first thought was to get motion sensing flood lights that actually worked. Since we were having the siding replaced on our home, I thought that this would be a great time to do something about the flood lights as well. ![]() There was a motion sensor attached that had never worked.Īnd being “just a bit” forgetful – I would always end up leaving the outside lights on during the day – and kick myself for it. We inherited our old flood lights from the previous owners of our home. The lights should turn on for a few seconds and then automatically turn off.Why We Were Upgrading Our Old Outdoor Flood Lights Install the light bulbs and turn the breaker back on. This is to help prevent water from getting behind the fixture, and by leaving the bottom un-caulked, it gives the water a way out of the fixture if any happens to still get in. Run a bead of caulk along the top half of the fixture but not all the way around the bottom. Secure the security light to the wall box and make sure all of the wires are inside the box and none are hanging out. When making these connections, twist the copper ends of the wires together using the needle-nose pliers, then secure each connection with a wire connector and wrap each one with electrical tape. ![]() If the photo sensor is NOT pre-wired, then connect the white wire from the photosensor to the other white wires in the box, connect the red wire from the photosensor to the black wire from the fixture and connect the black wire from the photosensor to the black wire(s) in the box. ![]() If the dusk-to-dawn security light is brand new, the photo sensor will already be pre-wired so all you have to do is connect the black wire to the black wire(s) as instructed above. Twist the copper ends of the wires together using the needle-nose pliers, then secure the connection with a wire connector and wrap the connection with electrical tape.Ĭonnect the black wire from the fixture to the black wire(s) in the wall box by twisting the copper part of the wires together with the needle-nose pliers and securing the connection with a wire connector. The gasket comes packaged with the security light and is required in order to prevent water from getting behind the fixture and into the wiring box.Ĭonnect the ground wire from the dusk-to-dawn security light fixture to the ground wire in the wall box using a wire connector.Ĭonnect the white wire from the fixture to the white wire (or wires if another light is fed from this same circuit) in the wall box. Place the weatherproof gasket onto the security light before the wire connections are made.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |